Water pipes are concealed works in home improvement, and maintenance is very troublesome. Buying good quality water pipes can save you from worries. Here are a few common tips for choosing a water pipe for home improvement.
1. PPR pipes, steel-plastic pipes and copper pipes are generally used for home decoration pipes. The price of steel-plastic pipes is relatively high, while the price of PPR pipes is higher than that of steel-plastic pipes. The price of copper pipes is the most expensive, and the price is equivalent to that of PPR pipes. 4 times or so.
2, home decoration laying pipes should try to avoid laying from the ground, preferably from the top or wall, the pipe usage may increase slightly, but it is conducive to future pipeline maintenance.
3, the wall thickness of the hot and cold water pipe is not the same, the cold water pipe can not be used as a hot water pipe, the easy way to distinguish the hot and cold water pipe is a red line mark on the hot water pipe.
4, the standard length of PPR pipe is four meters each. When buying, please ask the price of each pipe or the price of pipe per meter. After the pipe is sent, remember to check whether the length of the pipe meets the requirements.
5, the water pipe for home decoration should pay attention to the pipe diameter and wall thickness, the general pipe should use 6 points, the pipe can be used to 4 points, in order to ensure the water consumption, the pipe can also use 6 points.
6, when the home decoration purchase pipe, pay attention to whether the inner diameter of the pipe is symmetrical, the uneven diameter of the pipe diameter will affect the docking of the two interfaces.
7. The “Construction and Decoration Engineering Quality Standard†of the Building Decoration Industry Association has such a regulation on the time and pressure of the pressure test: the newly installed water supply pipeline must be subjected to the pressure test according to the relevant regulations. Metal and composite pipe test pressure 0.6MPa, voltage regulation for 10 minutes, pipe pressure drop should be no more than 0.02MPa, no leakage; plastic pipe test pressure 0.8MPa, voltage regulation for 20 minutes, pipe pressure drop should be no more than 0.05MPa, no leakage.
Aluminum Casting Machinery Parts
Aluminum Casting Machinery Parts,Aluminum Machinery Parts,Agricultural Machinery Parts,Machinery Spare Parts
NINGBO AIKEHAN METAL PRODUCT CO.,LTD , http://www.diecastingsupplier.com