Several Methods to Treat Loose Ceramic Tiles

Expert Weapons: Several Methods of Treating Loose Ceramic Tiles

Ceramic tile is not completely loose

The difficulty in dealing with this problem is that when you take out the tiles, it may cause damage to the tiles. This may involve the replacement of damaged tiles. If you do not reserve spare tiles, then you should sell them with your tiles at that time. Whether or not the product can find the same color number (the same model of product, if not the same batch of production, the color may be different) of the product, to make up some of the same color tiles. The tile is split from the middle and the crowbar is used to carefully move the damaged tiles from the center to the periphery. This will not cause damage to the surrounding tiles. After removing the tiles, follow the instructions below. You can.

It can also be processed by grouting, that is, the cement mortar mixed with 108 glue penetrates into the bottom of the tile from the gap of the tile to be processed. (This method of treatment is a palliative method that does not completely solve the problem of loosening of the tiles. It may still cause looseness after a long period of time.) In addition, after the ceramic tile is treated by the above method, the ceramic tile is not Don't walk on it before you dry!

Completely loose tiles

In this case, the processing method is relatively simple. First, carefully remove the bulging ceramic tiles. Then, clean the dust and impurities on the back of the tile and the base layer of the floor. Use a special tile adhesive to paste. Because it is a floor tile, there will be certain requirements on its compressive resistance. When pasting, the tile adhesive on the back of the tile can be evenly applied on the back of the brick, avoiding the emptying of the tile as much as possible (of course, the best treatment method is still to use cement. Mortar paste is good.)

Decoration experience tile paving tile cement tile adhesive

All Poplar Plywood, Poplar Plywood Sheets, Poplar Core Plywood

General size parameters of poplar plywood:
Size:
1220mm*2440mm
Thickness: 5-20mm
Forming: one or two times.
Poplar veneer: color or mahogany awgu or bleached poplar skin etc.
Sandwich: the whole core or broken core
Glue: /E2/E1
Widely used in sofa, flat panel furniture, solid wood composite furniture......etc..

LVL for constructionLVL-Lumber-LVL-Timbers



All Poplar Plywood

All Poplar Plywood, Poplar Plywood Sheets, Poplar Core Plywood

HUAIAN HONGXIN INTERNATIONAL TRADE CO.,LTD , http://www.hongxin-trade.com

This entry was posted in on