Problems to be aware of when renovating a sheet:
1. Plate nails and nail caps must have a cross groove, which can be drilled by hand. With a hammer + a scorpion, it is easy to bruise the plate, and it is very difficult to pick it up.
2, the wood keel of the plate can not be saved, to buy a good wood keel. This will avoid the construction and maintenance of the following.
3, when laying the keel, you should look at the practice of the line pipe. Can consult the relevant construction personnel.
4, I don't know when I bought the black walnut wood splint. I came back and rubbed the paint again. It was black, and later I knew that it had been processed at the factory.
5, with solid wood panels, easy to warp, the wear of some places is particularly ugly.
6, the gap is small, the solid wood plate is a bit loud.
7, public places, floor tiles better than reinforced panels.
8. Reasons for strengthening the plate sound: Did you hit the keel when you installed it? If it is, it is because the keel and the ground are not firmly fixed, and the gap is generated, so it makes a sound. If there is no keel, it may be in a place where the movement is frequent, and it may be the reason why the safety is too tight, resulting in a sound.
9. Before you want to ceiling and make solid wood panels, please be sure to pay attention to whether your city's net height is allowed. At the beginning of the project, if you do not think about whether to use solid wood panels or solid wood composite panels (composite panels), the construction team must be required to lay the wires in accordance with the way of laying the panels (walking the wall or slotting on the ground).
10, brick-concrete structure house is recommended not to use solid wood panels within 4 years, because the rain may seep into the bricks, the frame structure is no problem
Sanding Disk Grinding Apparatus,Grinding Wheel Grinding Apparatus,Wheel Grinding Apparatus,Grinding Apparatus
BEIJING FINECAST INTERNATIONAL CORPORATION , https://www.cfic-finecast.com