Electric doors are all kinds of doors that are driven by motors. Here's how to install it.
(1) determining the position of the indoor control box, that is, the position of the device that operates the telescopic door switch;
(2) Leading the 220V power supply to the lower end of the control box. It is better to have one grounding wire, the thickness specification is 1.37, and there is a leakage protection device, and PVC is used for darkening;
(3) Reserve ¢32mm PVC pipe, from the lower end of the control box down to the ground level, through the wall to the outside, to 0.1-0.15 meters below the ground plane of the track, for the outdoor door of the retractable door to enter the room;
(4) According to the above table, the length of the door opening is obtained. When the door is opened, the clearance in the width of the hole is not less than 0.75-0.8 meters. The height of the ordinary door is not less than the height of the door + 0.25 m, and the door is not less than the height of the door + 0.1 m. The upper end of the inner side of the end is 0.4 m wide and 0.6 m high, and the total length of the door can be increased by 0.2-0.3 m. This can be used to change the access hole into a small door for easy maintenance and maintenance of the retractable door. line;
(5) Before leaving the track, except for leaving about 0.8-0.9 meters wide, do the ground on both sides first; after 2-3 days (5-7 days in winter), while laying the track, the civil works will be coordinated At the ground, pay attention to the passage of the road during the laying of the track, so as not to bend the track;
(6) Install the retractable door, connect the line, and debug the switch control box.
Concerned about surprises
Label: Installation tips for electric doors
Previous: What should I do with the cracking of the wall paint? Next: What types of odor-resistant floor drains?
Zhejiang Changxing Senda Bamboo & Wood Products Co.,Ltd , https://www.sendaflooring.com