Float trap works

First, the basic function of the float trap is the condensate in the steam system, air and carbon dioxide gas emissions as soon as possible; the same time, to maximize the automatic prevention of steam leaks. Second, the ball float trap structure is simple, the internal only a fine grinding of stainless steel hollow float moving parts, both float and opening and closing pieces, non-wearing parts, long life, YQ trap with Y series Automatically discharge air device, very sensitive, automatic exhaust air, high quality work. Third, the equipment just started work, the air inside the pipeline after Y series automatic exhaust air discharge, low temperature condensate into the float trap, condensate water level rise, the float rises, the valve opens, the rapid discharge of condensate , Steam quickly into the equipment, equipment, rapid heating, Y series of automatic exhaust air device temperature of the liquid expansion, automatic exhaust air device is turned off. Float-type steam trap began to work normally, the float with the condensate level rise and fall, block steam drainage. Free float ball valve seat is always below the liquid level to form a water seal, no steam leakage, energy saving effect. Minimum working pressure 0.01Mpa, from 0.01Mpa to the maximum operating pressure range from the impact of temperature and pressure fluctuations, continuous drainage. To the saturation temperature condensate water, the minimum undercooling is 0 ℃, heating equipment without water, make the heating equipment to achieve the best heat transfer efficiency. Back pressure rate greater than 85%, is the production of process heating equipment, one of the best traps.

This entry was posted in on