Why do we want to hang the ceiling? Because the ceiling will look very strong in the living room, and it will lengthen our overall line of sight, making the space look a lot bigger than the actual look. But how much do we know about the ceiling process? Don't worry, let's take a look at the editor!
For the construction of the suspended ceiling, the elevation line should be ejected on the wall first, and the pressure line should be fixed at both ends of the wall, and the cement nail and the wall surface are fixed firmly. According to the design elevation, the line around the wall is used as the standard line for ceiling installation, and the horizontal tolerance is plus or minus 5 mm. When the algae well is suspended, the bead should be fixed from below, and the yin and yang angles should be connected by a bead.
Also note that the exit of the lighting line is reserved. When the ceiling area is large, the keel should be laid in the middle. The spacing of the lifting points should be re-examined, generally not 1200~1500mm for the ceiling, and 900~1200mm for the ceiling. Before installing the panel, the installed keel and panel panels should be inspected and installed after meeting the requirements. The grille ceiling is also very stylish. The role of the wooden grille ceiling is that it is often used in home decoration corridors, porches, restaurants and spaces with large roof beams. First, the production of the wooden grille skeleton should accurately measure the size of the ceiling. The keel shall be finished, the surface shall be planed, and the joint shall be open. The intersection of the horizontal and vertical keels shall be overlapped by a half-slot and shall be treated with a flame retardant.
Finally, the algae ceiling is seen from the requirements of the wooden keel installation. In the case of materials, the wood is required to ensure that there are no quality defects such as cracking, corrosion, insect frogs, and dead knots. The specifications are 30~40 mm in section length, 40~50 mm in width and less than 10% in water content. In terms of design, the algae type ceiling is adopted. If the height difference is greater than 300 mm, step layer classification should be adopted. The keel structure must be strong and the distance between the large keels should not be greater than 500 mm. The keel must be fixed firmly.
After reading these classifications, do you think that the doorway of the decoration is really quite a lot? It doesn't matter, the editors are willing to share the most detailed and clear knowledge to everyone!
Carbide Spherical Button,Carbide Button Insert,Carbide Button For Drilling Rock,Tungsten Carbide Button For Drilling
Zhuzhou Kerui Cemented Carbide Co., Ltd. , https://www.carbide-china.com